This 4 channel chaser runs 13-19 feet of EL Wire
This 4 channel driver is a Constant light & flash show . Uses 4 AAA batteries (not included) so you can make it mobile. Use it with pre-connected El Wire for simplicity or attach a lead to each section of your EL Wire and you can swap their locations on the Constant light & flash driver as you please. Each channel needs to have a load (EL Wire) on it for the driver to run. Do not operate without EL Wire on each connector. This can damage the unit! Runs off 110 volt or 4 AAA batteries. Comes with 4 EL Wire leads and on/off switch.
Dimensions: 3.5" x 2.25" x .875"
Diameter of Wire for Polar Bright 2 wire
2.2 mm Tail
All the above PL2 wires on this driver can do 13 - 19 ft
Diameter of Wire for Polar Bright 3 wire
2.6 mm PL3
5.0 mm PL3
Color Blast PL 3
All the above PL3 wires on this driver can do 7 - 10 ft